Change dell openmanage switch administrator password

CHANGE DELL OPENMANAGE SWITCH ADMINISTRATOR PASSWORD INSTALL
CHANGE DELL OPENMANAGE SWITCH ADMINISTRATOR PASSWORD SERIAL
CHANGE DELL OPENMANAGE SWITCH ADMINISTRATOR PASSWORD SOFTWARE

After you have correctly set up the terminal, plug the power cable into.

Windows 2000 Service Pack 2 allows you to use arrow keys in Operating system, ensure that you have Windows 2000 Service Pack 2 or later NOTICE: When you use HyperTerminal with the MicrosoftВ® WindowsВ® 2000 That you select Terminal keys ( not Windows keys).

Select Terminal keys for Function, Arrow, and Ctrl keys.

Under Properties, select VT100 for Emulation mode.

Set the data format to 8 data bits, 1 stop bit, and no parity.

CHANGE DELL OPENMANAGE SWITCH ADMINISTRATOR PASSWORD SERIAL

Select the appropriate serial port (COM port 1 or COM port 2).

CHANGE DELL OPENMANAGE SWITCH ADMINISTRATOR PASSWORD SOFTWARE

Set the terminal emulation software as follows:

Connect the other end of the cable to a terminal or to the serialД¬onnector of a computer running terminal emulation software.

Connect the female connector of the RS-232 cable directly to theД¬onsole port on the switch, and tighten the captive retaining screws.

To connect a terminal to the console port:

A null modem or crossover RS-232 cable with a female DB-9 connector for the console port on the switch.

A terminal or a computer with both a serial port and the ability to emulate a terminal.

To use the console port, you need the following equipment:

This port is a male DB-9 connector, implemented as a data terminal equipment (DTE) connection. The switch provides an RS-232 serial port that enables a connection to a computer or terminal for monitoring and configuring the switch. The switch supports the Dell PowerConnect RPS-600 external redundant power system.Д¬AUTION: Do not use the switch with any redundant power system other than the Dell PowerConnect RPS-600.

Insert and tighten two screws through each of the mounting brackets.

Align the holes in the mounting bracket with the holes in the rack.

Use the supplied screws to attach a mounting bracket to each side of.

CHANGE DELL OPENMANAGE SWITCH ADMINISTRATOR PASSWORD INSTALL

You can install the switch in most standard 19-inch (48.3-cm) racks. The rubber feet, although optional, are recommended to keep the unit from slipping.

Attach the rubber feet on the marked locations on the bottom of the.

Set the switch on a flat surface and check for proper ventilation.ДЄllow at least 2 inches (5.1 centimeters ) on each side of the switch and 5 inches (12.7 cm) at the back for the power cable.

The switch must have adequate space for ventilation and for accessing cable connectors. Install the switch on a level surface that can safely support the weight of the switch and its attached cables. The switch is supplied with rubber feet for stationing it on a flat surface and mounting brackets and screws for mounting the switch in a rack. The correct Internet Protocol (IP) settings.Д«efore you connect to the network, you must install the switch on a flat surface or in a rack, set up a terminal emulation program, plug in the power cord, and then set up a password and IP address. NOTICE: Do not connect the switch to the network until you have established

Self-adhesive rubber pads for desktop installation.

Installation: Dell PowerConnect 5224 SystemsД«efore You Connect to the Network: Mounting Kit InstructionsД«efore you begin installing the switch, confirm that your package contains the following items:

Change dell openmanage switch administrator password